MX-5 OC Forum

Mazda Super Coolant - Ethylene-Glycol based Pre-mixed (Green) Part Number: C050-CL-005 Replacement interval: 4 Years then 2 Years Long Life Coolant (FL22) - Ethylene-Glycol based Pre-mixed (Green) Part Number: C122-CL-005A Used in NC (MK3). Check for "FL22" on filler cap Replacement Interval: 11 Years (5 years ...

To check for DTC on the ABS system on MX-5 turn ignition switch to off, bridge the TBS and GND terminals in the DIAGNOSTIC socket under the bonnet, turn the igniton switch to on and count the groups of flashes on the ABS lamp. Long flashes count tens, short flashes count units. To clear DTC, allow all codes to be output (flash codes repeat) ...

You can tow with a Mk1. You cannot legally tow with any other mark. Mk1 Towbars available from http://www.towequipe.co.uk/products//drivemz26-witter-fixed-towbar-mazda-mx5-1990-to-1998.html

Its one of those £25 kits of ebay(so we'll see how long it lasts). It took 5 hours to fit from scratching head to locking doors. I hope it is of use to someone The passenger door mount.....(close up) Top view, note how bottom bracket is bent out to prevent window from catching motor Driver side mount...... Passenger door ...

If you can't just pull your brake disc off the hub, after removing the brake calliper, first try tapping the disc from behind with a soft faced mallet. If this doesn't work, there is a threaded hole in the disc, insert an M5 bolt and turn the disc off by tightening the bolt into the hole. make sure the bolt is 10mm longer than the ...

Had done a few thousand Km then felt the lever go "too far" over when selecting 5th. Had to do a 150ml round trip with the first part on motorway, got into 5th and was OK. On leaving the motorway could only find 2nd and 3rd and in the end when I came to a set of lights lost the lot and the stick was all over the place. Called out ...

I just changed all my pads on our MK3!!! Mazda wanted £350 plus MOT and third sevice!!! I used green stuff pads all round from MX 5 Parts for £109. First thing for the fronts you will need a 14mm socket and 19mm and a 4" G clamp to push the piston back in to the caliper housing and  some copper  slip grease and some ...

Early layout. Later fully populated layout (unlikely to find all terminals populated on MX-5 though)

Owners Club members can download PDF's of the How-to guides as featured in past issues of Soft Top Hardtop. Replacing Cam Cover Gasket and Crank Angle Senor O Ring NA Changing Rear Discs & Pads NA & NB Replace Front Dampers (1 of 2) NA Replace Front Dampers (2 of 2) NA Replace Rear Dampers NA Replace Engine ...

Here's the photos & links:- The kit- http://i35.photobucket.com/albums/d185/Goof-UK/S%20Special/Central%20Locking/DSC00448Medium.jpg http://i35.photobucket.com/albums/d185/Goof-UK/S%20Special/Central%20Locking/DSC00449Medium.jpg http://i35.photobucket.com/albums/d185/Goof-UK/S%20Special/Central%20Locking/DSC00443Medium.jpg ...